WiseRail Heritage Cable Railing - Outside Mounts for Wood Posts

by DeckWise
SKU: DWSWRHS
from $22.13
from $22.13
Ships Free with $99 Order

Please select options before adding to cart

In Stock

Usually Ships Same/Next Business Day

Share This Product
Our Return Policy
Share This Product

The WiseRail Heritage Cable Railing -Outside Mounts for Wood Posts is a budget-friendly cable railing for any type of wood post as an outside to outside fitting on a straight level run, on a pitch or stairs. The tensioning device is a 2-7/8” long threaded stud which installs on the back side of one end post. A Pull-Lock fitting is installed through the other end.

This through-the-post configuration is the only scenario in which the economical threaded stud kits may be used. The threaded stud kits are even more economical than the WiseCable Heritage Series, but the threaded studs are a basic, functional fitting, not a hide-in-the-post solution. A brass hex nut and some metal thread will extend beyond the back of the post on one end and can be covered by an end cap (purchased separately). A Pull-Lock fitting is installed through the other end.

Use the WiseCable Heritage Series for decks with dedicated end posts for each run where the posts are situated where the back sides of the posts are all accessible. This is both the most economical solution and where the fittings are least visible.

For wood posts on a pitch or stairs, install the WiseCable Heritage Series the same as on straight runs. The tensioning device is a 2-7/8” long threaded stud which installs on the back side of one end post. A Pull-Lock fitting is installed through the other end with a post protector tube (sold separately). The WiseCable Heritage Series can be used to go up a stair and across a landing by inserting post protector tubes in the break-over post. The tube will prevent the cable from carving a groove into your post where it exits at an angle.

Features

  • For wood posts on a straight run, on a pitch or stairs
  • Budget friendly
  • Outside to outside mount
  • Tensioning device is a 2-7/8" long threaded stud on one end and a pull-lock system on the other end.
  • Made from corrosion resistant, high-strength type 316 stainless steel
  • Sleek and beautiful design
  • Kit includes (1) 1/8" diameter type 1x19 stainless steel cable with (1) pre-attached 7-1/2" long threaded stud, (1) pull-lock fitting, with end cap (2) stainless steel washers, (2) stainless steel jam nuts
  • End cap to cover hex nut is optional and can be purchased separately
Specs
ManufacturerDeckWise
BrandDeckwise
Sub BrandWiseRail
Compatible Tools5/32 Drill Bit, 9/32 Drill Bit for Threaded Stud Intallation, 29/64 Drill Bit for Pull-Lock Installation, 7/32 Wrench for Holding the Stud, 7/16 Wrench for Tightening Jam Nuts, Cable Cutting Tool, If Using Post Protector Tubes, 1/4 Drill Bit
Diameter - Inches.125
Included AccessoriesStainless Steel Cap for Pull-Lock
Kit Includes(1) 1/8" Diameter Type 1x19 Stainless Steel Cable with (1) Pre-attached 7-1/2" Long Threaded Stud, (1) Pull-Lock Fitting, (2) Stainless Steel Washers, (2) Stainless Steel Jam Nuts, (1) End Cap
Package Quantity1
TypeCable Rail
Ships to HI/AKNo